Cause yur the cigarette and I m the smoker 63
Large camping trailers require any seven-way trailer plug.
The electrical program with some large trailer is more complex than the electrical system for a small trailer. Unlike their smaller brethren, large trailers often require additional lights, split change and brake data, also even internet brakes. While some four-wire trailer plug may work for some little trailer, this type regarding plug remains not suitable to connecting a large trailer to an vehicle . To tow a large trailer, you will need any seven-cable (or seven-way) trailer plug.
Instructions
things you'll require:
Seven-way automobile-side trailer wire harness connector Electrical pliers Screwdriver Wire splice connector terminals Installed electronic trailer brake unit
1 Pull each of the wires apart on the trailer harness. Loosen the screws holding the tail lamp housings to the automobile. Gently pull the tail lamp housings free of charge from the tail lamp frames because if you are going to replace the tail lamp light bulbs. Each and every wire in the automobile tail lamp assembly is usually marked with exclusive adhesive flag close to the base of the tail lamp housing.
2 Place one of the wire splice connectors over the left tail lamp ground wire. Place the free closure regarding the white wire from the trailer harness connector into the wire splice connector and crimp the connector hence that the splice connector makes a mechanical link by way of the wire pair.
4 Slip a new wire splice connector over the proper tail lamp wire. Insert the free conclusion of the green wire from the trailer harness in the wire splice connector also crimp the connector terminal to make the connection.
5 Place the fourth wire splice connector over the wire labeled "accessory." Put in the black wire from the trailer harness into the splice connector terminal. Crimp the connector terminal to make the link.
6 Place the fifth wire splice over the turn signal cable on the left rear side about the automobile . Insert the free end of the trailer harness red wire in the splice connector. Crimp the connector terminal to join the wire pair.
7 Slip the sixth splice connector above the right turn signal wire. Place the free closure of the brown wire from the trailer harness into the splice connector. Crimp the connector terminal to make the connection among the wires.
8 Place the seventh splice connector throughout the wire that illuminates the backup lights. Insert the free of charge end of the yellowish wire from the wire harness into the splice connector. Crimp the connector terminal to make the mechanical connection.
Tips & Warnings
Quite a few automobiles absence any rear "accessory" wire. You may desire to connect this wire to the positive wire on some fused circuit in the vehicle, such seeing that the cigarette lighter port or power stage.
References
Still Credit
train, trailer picture by way of Greg Pickens from web site
Print Email Share
Comments
